Montgomery Water Heater Odor Repair

Are you having a problem with foul odors originating from the water originating from your water heater? It could happen occasionally for a couple different reasons. Here is what Water Heater Repair Montgomery suggests to do to make sure your water smells considerably better and to get rid of any awful tastes fast.

Causes for Montgomery Water Heater Odors?

Bacteria getting in the water system is the most typical cause ones water in your own home could have odors. If you home uses well water or cities that make use of wells for the water supply, increases the likelihood of this happening.

With a water heater temperature setting of 140 degrees or above will help in cutting down on the development of germs within the water storage tank.

How to Remove Foul Water Smells

The following instructions discuss how you can use chlorine bleach to wash a water heater.

The electric or gas going to the water heater tank has to first be shut off.

Next, the cold water supply off that leads to the tank needs to be turned off.

Open the hot water faucet of the kitchen sink to allow air to enter the tank.

With a a yard hose attached to the storage tank drain valve, drain the water inside the water heater.

Then shut the drain valve once it is drained.

The next step is adding the bleach.
If the hose for the cold water travelling inside the storage tank is a flexible hose, unscrew it from the tank. Otherwise, one will probably need to take off the pressure relief valve, which is more involved. For electric water heaters, one of the elements can be taken out.

Make use of a funnel to put bleach into the tank.
Pour 5 ounces of bleach per gallon of the tank capacity.
So if you have a 50 gallon water heater, you would need 250 ounces of bleach, or close to 2 gallons.

Re attached the water line or pressure relief valve.

Fill the tank back up with water again.

Shut the hot water faucet of the kitchen area faucet as quickly as all the air is out of the line.

Operate all the hot water appliances up until the smell of bleach is evident. We want to eliminate the bacteria that can be found in the water lines likewise, not only inside of the water heater.

Allow the water to stand in the tank and water lines without using and hot water for 2 to 3 hours.

Drain the storage tank once more and refill it. This time allow it to remain for at least thirty minutes and yet again drain it.

Fill the tank back up. Turn on all of the hot water fixtures and let them run until the smell of bleach is gone.

For gas water heaters, relight the water heater pilot burner. For electric water heaters, turn the power on once more.

In addition, by replacing the anode rods, or even the type used can work as the following video shows:

Additionally, by replacing the anode rods, or perhaps the type employed can work as the next video shows:

Odors from Montgomery Water Heater

What the Experts Say

According to Soquel Creek Water District, “The smell is the result of four factors that must all be present for the odor to develop. These factors include:

  • A high concentration of sulfate in the raw water
  • Sulfate reducing bacteria, non-toxic to humans (sulfate is reduced to a sulfide state by the bacteria)
  • Little or no dissolved oxygen in the water
  • Hydrogen (a component of water which may be present due to water conditions reacting with the anode)”  Read more here…

Soquel Creek Water District

How is hydrogen sulfide gas produced in a water heater?

A water heater can provide an ideal environment for the conversion of sulfate to hydrogen sulfide gas. The water heater can produce hydrogen sulfide gas in two ways – creating a warm environment where sulfur bacteria can live, and sustaining a reaction between sulfate in the water and the water heater anode.  Read more…

Minnesota Department of Health

Check out some of our other water heater tips in our blog